Cutting out structual components without the proper equipment can result in a car that does not fit properly or may not even mount on the frame properly. With our Blackhawk frame machine, we can guarantee that your body structure will not move during the repair process.
Land & Sea engine dyno.
Our dyno is set-up to run Chevy, Ford, Mopar, Buick, Olds. Capable of holding 1600hp & 2000 foot pounds of torque. Learn where your torque and horsepower curves are, set the best timming, learn the optimum fuel to run, jet the carb to match your engine, check your exhaust gas temperatures, look for any leaks, listen for noises, break-in the enigne under a controlled enviroment, etc....
Our rotisserie gives complete access.
A rotisserie is used to allow us get to every part of your car with ease. After all the structal repairs are completed, the body is then ready to be put on the rotisserie. Watch as we detail this 1970 Chevelle SS conv. shell. Please notice the correct color on the underside and the correct undercoat and floor plugs.
High quality down draft paint booth.
All the vehicles are painted in a down draft paint booth and then baked for a hard shell finish. We paint all cars with the doors and deck lid installed, it is done this way to match the original factory process. All of the correct sealers have already been installed in all the correct places to insure a water tight body. We paint only where the factory painted. Watch as we paint this 1980 Z-28.